BASEBOARD
INSTALLATION

Using angle finder measure
the angle of the corner of the room.

Set the angle on the trimming saw,
make a cut on the product.
In rooms with 90° corners it is possible
to use a mitre box and a hand saw.

Apply «Evroplast Assembly» adhesive on the mounting
surface (only in the area of junction to the wall)
or «Evroplast Multipurpose» adhesive along the length
of the product. The thickness of the applied layer
of adhesive shall be 3-5 mm.

Affix the product to the place of installation
according to the marking on the wall.
Press the product along the whole length
so that adhesive exudes from under
the whole junction surface.

Immediately after attaching remove excess
adhesive using putty knife.

If necessary wipe the area of junction between
the product and the wall with a cloth wetted
with water if using «Evroplast Assembly» adhesive;
with acetone if using «Evroplast Multipurpose» adhesive.

Cut the next product. Check the joining
of the profile of products, if necessary
redo the cut.

Wipe the end surfaces of abutting products
with wet cloth to remove dust
and other contaminants.

Apply «Evroplast for bonding joints» adhesive
on the end surface of already mounted product.

Apply «Evroplast Assembly» or «Evroplast Multipurpose»
adhesive on the mounting surface (only in the area
of junction to the wall) of the next product.

Press the product to the wall and floor,
so that adhesive exudes from under the whole
surface of junction. While moving the product
along the wall, push it to the adjacent product
so that adhesive exudes from the joint.

Immediately after attaching,
remove excess adhesive using putty knife.

Wipe the joint with cloth wetted with acetone.

Continue mounting the next product.

After 3 hours sand the joints with fine sandpaper.

Fill the sanded joints with fine-grained,
water-soluble filler for interior works,
if necessary repeat step 15
until you get a flat surface (in 60 min).

Fill the joint of the product to the wall
with adhesive in those areas
where no adhesive exuded.

Wipe the excess adhesive with a cloth wetted
with water if using «Evroplast Assembly» adhesive;
with acetone if using «Evroplast Multipurpose» adhesive.

Paint the products, following directions
from the paint manufacturer, starting
from the corner of the room.