CEILING ROSE
INSTALLATION

Drill a hole in the product.

Apply the product’s outline on the ceiling.

Apply evenly on the mounting surface Assembly Adhesive
or Multipurpose Adhesive along the whole length.
The applied adhesive should be 3-5 mm thick.

Attach the item to the place of installation.
Push the item along the whole circular
length so the adhesive exudes
from the entire plane.

Using self-tapping screws fasten the rose to the ceiling.

Immediately after gluing remove
the excess adhesive with a spatula.

When using Assembly Adhesive, remove
the remaining excess adhesive by wiping
the areas with a cloth dampened with water;
use acetone if Multipurpose Adhesive is used.

Fill the area of screw holes with fine-grained,
water-soluble filler for interior works.

Treat the spackling area
with Fine grain abrasive paper.

Fill the spaces in the joint area between
the cornice and the walls/ ceiling,
where the adhesive has not shown on a surface.

Wipe the area of the joint
with a wet cloth. Wet the cloth with water
if Assembly Adhesive is used and with Acetone
in case of using Multipurpose Adhesive
or Adhesive for bonding joints.

Paint following the instructions of paint manufacturer
the rose and ceiling in case of need.