CEILING CORNICE
INSTALLATION

Firmly press the product to the wall
and the ceiling, make a mark
on the bottom edge of the product.

Using chalkline, connect the marks
on the perimeter of the room.

Using an adjustable square,
measure the angles of the room.

Using a mitre saw, cut the element
at the appropriate angle.
In a room with 90° angles a mitre box
or a handsaw can be used.

Apply evenly on the mounting surface
Evroplast multipurpose adhesive along the whole
length. The applied adhesive should
be 3-5 mm thick.

Attach the item to the place of installation,
using as benchmarks the previously
made marks on the wall. Push the entire
length of the item so
the adhesive exudes from the entire plane.

Immediately after gluing remove
the excess adhesive with a spatula.

When using Assembly Adhesive,
remove the remaining excess adhesive
by wiping the areas with a cloth dampened
with water; use acetone if Multipurpose
adhesive is used.

If additional attachment is required,
use screws at a spacing of ≈ 500 mm,
if the sizes of cross-section are more
than 100 × 100 mm or when installing
products on a mounting plane.

Make a gash of the next element.
Check the alignment of the cornices pattern.
Repeat saw cut if needed.

Mounting of the adjoining cornice:
remove the dust and other impurities
from the surface of the abutting
cornices with a wet cloth.

Bonding of the joints:
apply Adhesive for bonding joints on the side
surface of the already mounted cornice.

Apply Multipurpose or Assembly Adhesive
to the surfaces adjoining of the next cornice.

Press the cornice to the wall and ceiling
until the adhesive shows on the whole
surface of the joint. By moving the product
along the wall press to the next cornice
till adhesive appears at the joint.

Remove excess adhesive with a putty
knife immediately after bonding.

Wipe the area of the joint with
a cloth wetted with acetone.

Continue the process of installation
of the next cornice.

After 3 hours treat the joints
with fine grain abrasive paper.

Fill the treated area with fine-grained,
water-soluble filler for interior works,
repeat Step #18 if needed,
until you get a flat surface.

Using Evroplast Multipurpose adhesive fill
the spaces in the joint area between
the cornice and the walls/ ceiling,
where the adhesive has not shown on a surface.

Remove excess adhesive using wipe wetted with acetone.

Paint the cornice following the instructions
of paint manufacturer, starting
from the corners of the elements (room).